Jewelry believes that every woman loves it. There must be a jewelry jewelry in a woman's jewelry box. Jewelry is not only good -looking, but also a lot of benefits to bring people. When making jewelry, we are pursuing perfect Flawless, excellence, need to be strictly inspected when leaving the factory, and the requirements are very high. If you want to go out of the workshop, it is as difficult as the carp jumping the dragon door. do we need to care something?

1. Avoid placing the workbench under the sun, because the strong sunlight will seriously affect human vision, inlaid processing, especially when welding It is easy to cause problems such as virtual welding or excessive temperature caused by insufficient heating during welding.

2. During the processing process, in order to clean the surface of the workpiece or to weld the workpiece firmly, the heated workpiece must be placed in a chemical such as acid and alum. After the heating workpiece enters the acid liquid, it will produce a strong smell and corrosive gases. This gas will not only corrode the metal tools and equipment, but also harm the skin and skin. Therefore, setting up a good ventilation makes air circulation particularly important. It is best to set the ventilation pipes to the roof to avoid blowing the exhaust gas from the air back into the room.

3. Most machines and equipment in the workshop require power to start, and lighting also requires power supply. The installation of the power plug should be reasonable. The equipment that is closest to the most required for the power supply must have a dedicated socket, and you cannot share a socket with other devices. It is best to be a dark wire to avoid the wires across the workbench or near the fire and acid, because the wires are easily damaged, and the exposed wires are dangerous.

4. A adjustable height and orientation of the workbench should be installed on the workbench. It can not only light up from all aspects, but also does not affect inlaid processing. The lighting lights of the workbench are preferably made of electroplating metal hose and enamel lamp cover. Such lights are not only flexible, but also have anticorrosiveness.

5. The final process of the pavilion inlaid processing is polishing and cleaning. The dust produced by polishing is dirty, and the noise of the machine is also greater. In order to reduce pollution and noise, the best way is to separate the polishing equipment or seal the polishing equipment.