Friends in the industry know that samples are an extremely complicated process. Each time they need to pay a lot of time and energy, even if a small change will increase the workload of samples for several days. So, what is the process of silver jewelry sample?

   First of all, the guests will provide a silver jewelry sample during proofing. Of course, this is the most direct and effective provision. Not only does the samples make a high degree of similarity, but they also greatly shorten the proofing cycle. However, in general, guests are all. It can only provide drawings (some are still rough hand -drawn drawings). Because of the differences in concept, it is difficult for designers to read the needs of customers at a time, which makes a certain difficulty proofing.

   When silver jewelry proofing, the manufacturer will first charge a certain proofing fee for guests. This is not only the corresponding mold manufacturing cost, but also a reasonable constraint on the guests. , Guests may not be heard, even don't even spend anyway. Furthermore, the manufacturer only collects proofing fees symbolically, and for hundreds of sample fees, far from the actual cost of proofing.

    After receiving the proofing fee, the manufacturer will arrange 3D drawing for the first time. Generally, the drawing takes 2-3 days, but sometimes the manufacturer will have hundreds of proofing at the same time. In this case, it will need to be extended to 5-7 days to complete the drawing.

   After drawing the 3D picture, the guests confirm the first time that the guests can clearly see the entire wheel Guo and details of the product through the 3D picture. If you still do not understand, you can communicate directly with the designer.

  After confirming the 3D Figure OK, the manufacturer immediately arranged for the opening of the mold to do the original, using the original opening of the glue film, the wax of the wax after the rubber film was poured, and the sand was flipped (silver). Stone (if it is wax inlaid, it needs to be placed in a vermiculite before the wax injection). To do this, the silver jewelry sample is almost the same.

   Of course, silver jewelry proofing is not as simple as mentioned above.It is very unstable, and it is likely that the electroplating is a bad product. This requires returning electricity. In addition, there are many products in the plating plant. It is difficult to discharge production in time, which allows the proofing to extend the cycle.